|
||
|
New Member
加入日期: Mar 2007
文章: 3
|
Question for OC E4300
Good time all.I have some question base on the following specs:
Intel Core 2 Duo E4300 ASUS P5LD2 SE Kingston KHX7200D2K2/1G Seagate 80GB SATA(System) Seagate 80GB PATA(Backup) GeForce 7600GT 256MB 128Bit Original 550 watts PSU 1.)In the BIOS setting if using ASUS AI to set the FSB1333/DDR667 it will work but can't pass the SP2004 test because it will make my unit restart.What I can do? 2.)If in the BIOS use manual mode then set the CPU to 333MHz then DDR 666 it will not start after save the BIOS setting to CMOS.What I can do? 3.)I would like to set the CPU speed at 3.5GHz(389*9) then what kind of the setting I have to do? Thanks for your help^^ |
|||||||
2007-03-17, 01:21 AM
#1
|
|
|
Elite Member
  
加入日期: Nov 2001 您的住址: 高雄
文章: 5,077
|
引用:
1.maybe your NB too hot 2.set pci-e to 112-117 or change DDR2-ram Timeing to 5-5-5-15 3.Use LN2 and Set Vcore to 1.600V maybe Your E4300 Can RUN SP2004 @ 3.5G 此文章於 2007-03-17 01:50 AM 被 HanyuLee 編輯. |
|||
|
2007-03-17, 01:48 AM
#2
|
|
|
Amateur Member
 加入日期: Mar 2007
文章: 42
|
引用:
P5LD2 SE is the cost down version of P5LD2, and it's chipset is 945P. For my experience, 945P is hard to overclock more than 350Mhz frequency.  |
|
|
2007-03-17, 02:18 AM
#3
|
|
|
New Member
加入日期: Mar 2007
文章: 3
|
小弟把 PCI-Express 調整到 118MHz 然後所有電壓不變就可以順利的超頻到 3.0GHz(333*9) & DDR2 666.只是不知道把 PCI-Express 調整到 118MHz 會不會對小弟的電腦硬體有不良的影響呢??
|
|
2007-03-18, 05:05 PM
#4
|
|
