PCDVD數位科技討論區 - [求助]我的3COM 3CRWE554G72T 是不是掛了...

今天手癢想說更新一下韌體 3crwe554g72x_12Oct2005.exe ← 這個檔沒錯吧!!

結果也不知道更新韌體是要選下載下來的.exe檔還是執行完.exe檔後跑出來的.dlf檔

...我選了後者

結果按下開始→倒數70秒→掛點

192.168.1.1 進不去

開始翻全是英文的說明書找Reset的方法

1 Remove power from the Router.
2 Disconnect all your computers and the cable/DSL modem from the Router.
3 Using a straight through Ethernet cable, connect the Ethernet Cable/DSL port on the rear of the Router to any one of the LAN ports.
4 Re-apply power to the Router. The Alert LED will flash as the Router starts up, and after approximately 30 seconds will start to flash more slowly
(typically 2 seconds on, 2 seconds off). Once the Alert LED has started to flash slowly, remove power from the Router.
5 Remove the cable connecting the Cable/DSL port to the LAN port, and reconnect one of your computers to one of the Router LAN ports.
6 Re-apply power to the Router, and when the start-up sequence has completed, browse to:
http://192.168.1.1
and run the configuration wizard. You may need to restart your computer before you attempt this.
7 When the configuration wizard has completed, you may reconnect your network as it was before.

自己翻譯

1.移除Router的電源
2.把Router後面的網路線都拔掉
3.使用一條網路線，一頭接Cable/DSL port，另外一頭接任意一個LAN port
4.接上Router的電源，Alert燈會慢慢的閃，約30秒後，會閃的更慢，等到開始閃的更慢的時候，移除Router的電源
5.重接網路線(照原來正常的接)
6.接上Router的電源，等到啟動完畢後，開啟http://192.168.1.1
7.當設定精靈設定完成就OK嚕

我的問題出在步驟4，他沒有閃...所以感覺更本沒有Reset 囧...(換過網路線)

照上面的流程跑完一次後，192.168.1.1依然進不去 (電腦使用自動取得IP位置)

使用光碟中的設定精靈也抓不到Router

就是進不了系統網頁

我想現在應該就只剩下熱心的版友們和Reset能救我了

先謝了

跪泣中....Orz