我是先在此看過資料！
http://wiki.osx86project.org/wiki/i...3B_MSI_RS480.5D

也參考了其他資料，就是會停下來！
-----------------------------
Custom AMD [Athlon 64 3500+; MSI RS480]

Method: Native using Deadmoo image, 'Simple and Accurate' to copy to partition 5 on second disk, and copied Chain0 to Win XP partition to boot. Using Maxxuss 0.4 SSE2/3 patch.

* Note, the guide says this will not work on an extended partition, but it boots fine for me.

Hardware:

* AMD Athlon 64 3500
* 1GB memory
* On board RealtekRTL 8169 Ethernet claims it loads correctly, but haven't tested.
* On board AC97 (RealtekALC658C) won't work at all
* On board Radeon X200 works OK, but only VESA 2. Can't change resolution as monitor won't support the defaulted refresh rate.
* USB half works (see below)
* Doesn't see my SATA (first) hard drive, but recognises the other partitions on my IDE drive.

Comments: Needed to disable USB in the BIOS to get it to recognise the PS/2 keyboard and mouse, but the USB continued to work (for storage card, etc.) for a few re-boots, then mysteriously stopped working. Removed the ApplieIntel*.kext, though I'm not sure it was necessary. Also removed the TPM kext, as it was using 90% CPU Tried to install my Thomson Speedtouch USB ADSL modem, but it fails to load as it notices that the processor is not PowerPC (but why should it check?)
-----------------------------

其中，Deadmoo image 是啥東東呢？