不錯~~~為了感謝你的貢獻~~~本校長記你兩大兩小~~~~~~功~~~~

我試過左上角試用版的確會不見但每次開程式還是會問序號怎會這樣呢

還是會看得到欄位，不過真的是註冊成功了，所有的設定都可以用。
註冊不成功的話，有一些功能是不能選的。

執行後按 Start Program，將 Start Screen 換成另外的就可以了
見下圖紅色框框：

順便請教一下compression mode selective mode裡面的選項有何功能?

http://www.dvd2one.com/forum/viewtopic.php?t=512
英文轉中文就請大大們翻譯了

感恩喔\

官方網站直接摘錄下來...我看完不是很懂說
所以還是用原來的Variable Ratio...

DVD2one V1.5.0 released
New compression introduced, the selective ratio engine.

This new engine is a different way of approaching the video data! Selectable in three pre-defined levels, this new engine determines the balance in distincting the important screen parts from the less important ones.
Things that are not in focus in the current frame, like backgrounds, are low in detail or as we define it, of low importance to the screen.
and can be approached differenty than the important ones.

With this new compression method, setting the slider to low will lead into a scheme where the important parts of the screen are a bit more compressed than the less important ones. Compressing of low important parts can result into macroblock because the original encoder in a good encoder setup already achieved the best possible compression without loss of detail.
In medium the important parts are even more compressed than the non important parts, and in high the compression is almost done only on the important parts.

However in all three mode's the less important parts are still being compressed, because that is still mandatory to get the desired endsize.
By using this new method, the macroblocking (over compressed parts) will be less visible than with the conventional approach.
If they occur they will be more eye friendly shaped, meaning they are not 100% square but a bit more dithered shape.
The human eye will notice them less in this non square shape and thus resulting in a more pleasantly viewable version of the picture.

But all encoders are based on different motion detection scheme's, meaning there's no golden rule.
Most of the time setting it to medium will give you a very descent looking output, however with some encoders setting it to low or high might give a better quality output.
It's advisable to experiment with these settings on different discs from various distributors and view the end result on your setup by burning the video onto a rewritable disc.

selective mode 的Low,medium及Hight並非是絕對好或是絕對壞的影像壓縮方式...
取決你影片當時的壓縮的編碼.....所以可用DVD複寫片先燒出來測試看看....

以上大概是這篇文章主要說明的....對吧