PCDVD數位科技討論區
PCDVD數位科技討論區   註冊 常見問題 標記討論區為已讀

回到   PCDVD數位科技討論區 > 其他群組 > 疑難雜症區
帳戶
密碼
 

  回應
 
主題工具
idleic2
Master Member
 

加入日期: Mar 2004
您的住址: 亞洲.台灣.台北
文章: 2,054
我 對 multicast over 11g

很懷疑 這架構

之前 測過 , 在公司 網路 600台 PC 的 網芳的 multicast , 就
讓 wireless AP 的 wireless 無法回應 ping
multicast 流量 大慨 才 0.1~0.2 Mbps



另外 電力線 網路

有人用 85Mbps , 會有問題 !
用 200Mbps , 較保險 , 不過這也是 目前 最快的 電力線 網路 標準
     
      
舊 2008-05-08, 01:03 AM #11
回應時引用此文章
idleic2離線中  
idleic2
Master Member
 

加入日期: Mar 2004
您的住址: 亞洲.台灣.台北
文章: 2,054
如果 真的要 MOD無線化

選 11n 看看,

不然 只是 不要 網路線
還有 電力線 網路 200Mbps 可以 選

上上個月 裝 MOD , 就去買 電力線 網路 200Mbps

一對 3000 ~ 4000 元
 
舊 2008-05-08, 01:08 AM #12
回應時引用此文章
idleic2離線中  
cmwang
Elite Member
 

加入日期: May 2002
您的住址: 板橋
文章: 5,105
引用:
作者idleic2
我 對 multicast over 11g

很懷疑 這架構

之前 測過 , 在公司 網路 600台 PC 的 網芳的 multicast , 就
讓 wireless AP 的 wireless 無法回應 ping
multicast 流量 大慨 才 0.1~0.2 Mbps
snipped....


600台PC網芳的multicast讓wireless AP無法回應ping和此時能不能正確處理packet forwarding不一定是同一回事(i.e. packet forwarding是L2部份負責的,通常是H/W based,而ping是L3的,通常是SoC跑firmware的結果----SoC此時跑不動不代表L2 packet forwarding也一定跑不動 ),不過讓600台PC塞在同一LAN上也實在有點誇張就是了....BTW,鵝在Mobile01上看到有網友指出802.11要求對broadcast/multicast以基本速度來傳送(i.e. 1Mbps),不過鵝沒仔細看過802.11的文件,不知是不是這個原因就是了 ....
__________________
士大夫之無恥,是謂國恥....
舊 2008-05-08, 03:12 PM #13
回應時引用此文章
cmwang離線中  
noritsu
Basic Member
 

加入日期: Jul 2005
文章: 18
那電力線要選homeplug av 還是 DS2
各位大大有推荐的嗎?
舊 2008-05-08, 03:31 PM #14
回應時引用此文章
noritsu離線中  
idleic2
Master Member
 

加入日期: Mar 2004
您的住址: 亞洲.台灣.台北
文章: 2,054
引用:
作者noritsu
那電力線要選homeplug av 還是 DS2
各位大大有推荐的嗎?


homeplug av
舊 2008-05-09, 03:09 AM #15
回應時引用此文章
idleic2離線中  
a7432186
Power Member
 

加入日期: Aug 2006
文章: 694
照接線圖接


無線AP 要設定為 一般AP SWITCH 模式 (關閉DHCP 自動配發IP 模式)

無線網路卡都改為預設

應該就OK 不過會有缺點

就是必須使用 撥號連線 填入帳號密碼 在點播接上網(若數據機已經有DHCP功能就不用)


此文章於 2008-05-09 08:03 PM 被 a7432186 編輯.
舊 2008-05-09, 08:01 PM #16
回應時引用此文章
a7432186離線中  
cmwang
Elite Member
 

加入日期: May 2002
您的住址: 板橋
文章: 5,105
FYI:以下引自Multicast in 802.11 WLANs: An Experimental Study....

引用:
Multicasting video instead of streaming individually each video results in a much more efficient use of the shared wireless medium. Whereas all these new applications are very likely to appear soon with upcoming WiMAX or DVB-H enabled devices, the IEEE 802.11 standard does not comply with multicast data requirements. In particular, the current MAC layer sends multicast packets in open-loop as broadcast packets, i.e., without any possible acknowledgements.
This open-loop transmission mechanism causes three main problems. First, without feedback mechanism, it is not possible to adapt the contention window according to the network state, as it is done with regular point-to-point connections. Consequently, multicast achieve a higher priority than concurrent unicast and the network may become severely congested and could collapse. Second, it is not possible to adapt the physical (PHY) transmission rate to the channel characteristics, so the packets are broadcast over the wireless medium at one of the rates included in the
basic rates set. Third, there is no way to retransmit lost packets at the MAC layer, so the transmission is more lossy than for unicast , which degrades performance of the multicast application.


看來802.11先天上還真是不適合直接拿來送multicast就是了,不過有些AP有強調適應multimedia的部份,不知是不是有針對這些部份避開802.11的先天限制 ...

此文章於 2008-05-10 11:07 AM 被 cmwang 編輯.
舊 2008-05-10, 11:04 AM #17
回應時引用此文章
cmwang離線中  


    回應


POPIN
主題工具

發表文章規則
不可以發起新主題
不可以回應主題
不可以上傳附加檔案
不可以編輯您的文章

vB 代碼打開
[IMG]代碼打開
HTML代碼關閉



所有的時間均為GMT +8。 現在的時間是09:10 AM.


vBulletin Version 3.0.1
powered_by_vbulletin 2025。