自己插兩條去試試1T跟2T不就好了

雙面開2T,單面才能開1T(以插滿4支來說)

先了解一下什麼是Command Rate,就知道為何有1T/2T之別,也不會去強求8bank還要跑1T Timing了

Command Rate

Common Options : 1T, 2T

Quick Review

This BIOS feature allows you to select the delay between the assertion of the Chip Select signal till the time the memory controller starts sending commands to the memory bank. The lower the value, the sooner the memory controller can send commands out to the activated memory bank.

If the SDRAM command delay is too long, it can reduce performance by unnecessarily preventing the memory controller from issuing the commands sooner.

However, if the SDRAM command delay is too short, the memory controller may not be able to translate the addresses in time and the "bad commands" that result will cause data loss and corruption.

It is recommended that you try the 1T command delay for better memory performance. But if you face stability issues, increase the command delay to 2T.

http://www.rojakpot.com/showFreeBOG...ang=0&bogno=194