|
||
|
Power Member
 加入日期: Sep 2001 您的住址: 彰化
文章: 652
|
更新1394外接盒的韌體Oxford 911
我有一個3.5的外接盒，oxford 911晶片組，被我更新韌體時失敗了，不知道有哪位大大知道方法可以救回來。
送原廠的方法不行，因為我根本不知道是哪一間做的，也可能過保固了。 |
|||||||
2004-03-18, 08:42 PM
#1
|
|
|
Power Member
加入日期: Jun 2000 您的住址: 夢想國
文章: 668
|
請搜尋相關文章!!
還有你灌的911更新工具裡面有 還原的程式~~ 請詳細閱讀 相關說明檔~~ |
||
|
2004-03-18, 09:00 PM
#2
|
|
|
Major Member
加入日期: Nov 2003 您的住址: 漢江邊
文章: 149
|
回覆: 更新1394外接盒的韌體Oxford 911
引用:
全文在這裡... http://dvdpro.club.st/firmware/Oxford/Readme.PDF 節錄相關說明如下... Force flash mode If all else fails, the OXFW900 has a force flash mode to turn off the internal processor and force the device into programming mode. This mode is entered by temporarily grounding pin 123 while the device is powered. The device will then BUSY all requests except quadlet writes to offset 0xF0080000, the flash programming port, making the device appear blank to the programmer. To program in this mode, plug in and power the device, pull pin 123 low, then release it, then program as normal. The OXFW911 also has a force flash mode that can be used when the device is NOT powered. Short pin 57 of the OXFW911 to ground and then apply power. Powering up with this pin grounded will cause the device to enter “Force Flash” mode and the flash port will be enabled. NOTE: Pin 57 should then be open circuit before attempting to program the internal flash. Programming the flash must then be performed using the FW9 utility as the flash will be completely blank (hence it will not contain the firmware uploader which is present after manufacturing of the OXFW911 device). See the “FW9” subdirectory of the “OXFW900 Uploader” directory. 以上...
__________________
非官方 BenQ 明碁電通 DVD 燒錄器韌體網頁 正揚/俊揚/世揚/瑞揚事件簿...by_yangjiy 正揚/俊揚/世揚/瑞揚 賣的所謂 "NuSlim 832S", 請看此... 
此文章於 2004-03-19 01:50 AM 被 pc_dvd.tw 編輯. |
|
|
2004-03-19, 01:45 AM
#3
|
|
|
Power Member
加入日期: Sep 2001 您的住址: 彰化
文章: 652
|
謝謝兩位大大,小弟已經解救完成,但是uploader顯示成oxford 900,不知道該怎麼辦, 使用上似乎沒有影響
|
|
2004-03-20, 04:23 PM
#4
|
|
