The following Acronis products have full Solid State Drive (SSD) support:

Acronis Backup & Recovery 11
Acronis True Image Home 2011
Acronis True Image Home 2012
Acronis Disk Director 11 Home

All other Acronis products support Solid State Drives (SSD) with certain limitations:

You can perform all the same operations with SSDs as with regular hard disk drives;
There are no special partition alignment mechanisms required to keep the partitions offset which is optimal for SSD drives. In other words when you restore an image to an SSD drive, it will get the default 63 sectors offset instead of 64kb (or a multiple of 64kb) offset recommended for SSD drives even if this offset was in place when the image had been created. This may result in a drop of performance on certain models of SSD drives after the restore;


嘿.....




但是這有什麼鳥用呀??........因為...除非直接還原整顆硬碟.....再加上原本那顆硬碟空間比SSD小.....True image才有可能動作並分割正確partition對齊吧....

像我原本1.5T硬碟分割C(60G),D(1T),E(4xxG).......要將C分割移到新的SSD....我也不知能怎麼做.......印象中True image Disk to Disk 要將大硬碟(就算只使用一點點)對拷到小硬碟似乎也是不允許的.....
好像True image 也沒有partition to disk的操作....只能partition to partition ....但partition to partition 沒動到分割....它是不能幫你對齊的.....

最後....我只能先用diskpar先分割對齊SSD....然後再用True image partition to partition 將C備份移到SSD上.......