http://www.dd-wrt.com/wiki/index.ph...G54_soft_repair
請自己消化
我的理解是下面這樣
1.Set your computers ethernet cable interface to static IP address: 192.168.11.2, Network Mask: 255.255.255.0 and Gateway IP: 192.168.11.1
2. Connect the network cable to the bricked routers LAN port 4
3.In Windows cmd interface start a "ping -t -w 10 192.168.11.1", continuous ping every 10 milliseconds
4.Push the reset button (located in the buttom of the router), and keep it activated
5.Unplug the routers 5v power cable, count slowly to 5 and reconnect the power cable.
6.Count once again slowly to 5 and release the reset buttom
執行完這六步後接著
1.Run 'Draytek Firmware Upgrade',
2.Specify your *.bin file.
3.Plug in your router and hit send, if you get a "can't send" message, hit ok and try sending again. As long as you have a manual IP address on the same subnet as your router, and your router is pingable, it should eventually go through (reboot the router if you can't send for more than a minute).
4.When the send is successful, you should see a progress bar as the file is sent.
5.Wait approximately two minutes, and your router should become accessible.
或者照TFTP安裝DD-WRT的步驟,裝DD-WRT
http://www.dd-wrt.com/wiki/index.ph...s_under_Windows
--
以上皆參考網頁說明 本身無修復buffalo AP的經驗
成功那就恭喜你,失敗或者變更慘不要找我 (修復最好本身要有 linux的經驗 要不然遇到問題會不知所措)