瀏覽單個文章
ivantw
Junior Member
 
ivantw的大頭照
 

加入日期: May 2005
您的住址: Autobahn, Deutschland
文章: 743
使用HDAT2欲設定ERC,請問Read/Write Command Timer應該設多長?

引用:
作者thx
HDAT2 ,HDDSCAN,MHDD,Victoria 這是四大免費磁碟軟體. 不過作者群幾乎都在Data Recovery產業工作..

Linux 下用smartctl -l scterc,0,0 /dev/sda - disable read and write ERC
就可以關掉

以下出自於 T10 SCT 指令集
http://www.t10.org/t13/docs2005/DT1701r5-SCT.pdf
這次我就先不翻了.看有沒有高人翻的好.跟表現實作可加入OSSLab VIP 名額.

Error Recovery Control command

The Error Recovery Control command can be used to set time limits for read and write error recovery. For non-
queued commands, these timers apply to command completion at the host interface. For queued commands
where in order data delivery is enabled, these timers begin counting when the device begins to execute the
command, not when the command is sent to the device. T...
舊 2010-11-01, 11:26 AM #26
回應時引用此文章
ivantw離線中