我想ps2用m350+dscaler可能是不錯的.重點我不須花半毛錢.
如果是xbox.當然我會想要480p輸出vga.但m350辦不到.
我的lcd是170b(5)系列.而我去philips網站找到了manual.我看了約10份manual.都有支援sog.
so我想使用色差轉vga的方式.how to?我不知bnc為何?但我找到了此網頁http://www.xbox-linux.org/wiki/Xbox_VGA_HOWTO
裡面的英文我無法完全理解.
If your monitor supports Sync-on-Green you're lucky - you just need a plain cable to connect your AVIP connector

with your VGA monitor. No additional electronic components are necessary.
如果支援sog.LUCKY.你只需a plain cable去連結avip connector 和monitor....

The pin numbering below is with respect to the back of the AVIP plug, where the pads onto which you'll be soldering

are located, not the front of the plug, which enters the AVIP port.
下面是接角圖.是針對to the back of the AVIP plug,.pads的上面你必須焊的以標明.不是front of the plug, which enters the

AVIP port.

The connections of AVIP Pin 9 and 13 are necessary to select the cable ID. The above connections will result in a

cable ID of "2" (make sure AVIP Pin 11 is unconnected). This way Cromwell and the Linux kernel will be able to

detect the VGA cable and set the correct modes.
全不懂....

For audio signals, use AVIP Pin 2 (right channel), Pin 4 (GND), Pin 3 (left channel) and Pin 5 (GND).
對於音效.使用avip 第2針腳...第4....我懂
I recommend that you get a cheap Xbox SCART adapter, remove the SCART plug and solder a VGA plug.
我建議你拿一個便宜的Xbox SCART adapter....不懂

翻譯部份為英文的部份為不懂.
標不懂的為不懂.
能幫我翻譯嗎?
thank you