小弟買了一顆60G(TOSHIBA MK6022GAX)for notebook HDD
接在外接盒,卻出現裝置管理員可以看到這顆HDD
可是我的電腦內卻無法看到這一顆HDD
請問各位該如何解決?
我的NB USB是1.1,桌上型USB 2.0
兩台出現的訊息都是一樣的

我在網路上查到(USB chipset)
* 480Mbit/Sec USB2.0 interface to IDE/ATA/ATAPI bridge controller
* Single-chip SoC design
* ATA PIO mode 0-4, UDMA 0-5 support
* Dual ping-pong buffer to maximize data throughput
* Support both hard disk drive and optical storage devices like CDRW and DVDRW
* Boot-to-USB, bootable device support
* IDE master and/or slave device support
* Only one 12MHz low cost crystal is required
* Support PC, Mac and Linux platform

HDD information
60GB capacity
Rotational Speed of 5,400rpm
Fluid Dynamic Bearing (FDB) motor drive
9.5mm High
12ms Average Seek Time
ATA-5 Interface
100MB/sec Transfer Rate
16MB Buffer
300,000 MTTF Hours

我發現到ATA 部分有點不一樣
有可能是不支援嗎？
Thanks