為什麼我跑scandisk會有這訊息?
 

我的配備是技嘉GA-5AX BIOS:F4 ,加梭魚四 40G(用一個月),Win98 se
最近的硬碟還發生資料毀損讀不到的事情.我懷疑是和下面的messages有關.
但我搞不懂為何會有那些messages.我BIOS裡的硬碟是設AUTO,
開機時也抓成LBA模式了...我也用Notorn DiskDoctor掃過沒bad cluster.

下面是一跑ScanDisk就最先會出來的message:
ScanDisk cannot read from the last cluster on drive C.
This cluster is either damaged,or your system is not configured properly.
Drive C may need to have Logical Block Addressing(LBA) enabled to work
properly, or its disk partiton may be incorrectly marked as a non-LBA
partition. Data loss canoccur if your LBA setting or disk partition type for
this drive is misconfigured.Check your computer's BIOS setup utility, or
contact your computer manufacturer, or have your computer checked
by a qualified computer hardware technician.
If you are sure your drive is configured correctly, click continue to
have scandisk check drive C for errors.

感謝各位大大的解答...:)

硬碟的 Partion資料出現錯誤
建議你備份檔案 重新Fdisk試看看~~

感謝大大,今天花了一下午時間重fdisk重灌,問題終於解決了.