請教一個電腦問題
 

朋友的電腦有天突然出現以下的訊息就停住了
之前從未遇過這種毛病不知如果解決
請有經驗的大大...不吝指教..

Windows could not start because of a general computer hardware configuration
problem.
Attempting to load an x64 operating system, however this system does not
have the APIC configured.
Check your firmware settings. Make sure that the firmware has enabled the
advanced programmable interrupt controller (APIC) on this system. If the
firmware does not have an APIC setting, please contact the system
manufacturer for a firmware update to enable the local APIC.

到 BIOS 中將 APIC Mode 開啟

恩...
我在BIOS中只有找到ACPI..

也對CMOS放電清除過了..
還是沒辦法使用出現一樣的訊息

老一點的PCI卡可能不支援APIC
不然就是某介面卡故障了

他的電腦是整合型主機板
未外接任何的介面卡..
所以這樣說來應該是主機板故障嚕...0 0
要送修主機板想到就頭痛....

BIOS 調到default ,進window安全模式檢查晶片組driver,登錄檔
再不行重灌window,再不行...我投降

BIOS有load default....
連window都進不去..無法檢查driver..
重灌win倒還未試過..