![]() |
PCDVD數位科技討論區
(https://www.pcdvd.com.tw/index.php)
- 儲存媒體討論區
(https://www.pcdvd.com.tw/forumdisplay.php?f=20)
- - a7v880 找不到SATA硬碟..
(https://www.pcdvd.com.tw/showthread.php?t=534169)
|
|---|
a7v880 找不到SATA硬碟..
各位大大呀
小弟我已經打過數通電話給華X及hitaXXX嚕 可是問題不能解決.... 我買一顆 SATA2的硬碟 裝在只支援SATA1的華X A7V880上 在安裝XP的時候,也按F6裝上了主機板上的SATA DRIVE 也找不到硬碟.. 硬碟也經由店家分割 硬碟應該沒問題了.. |
VIA (威盛) 8237/8237R 南橋晶片不提供SATA-II 硬碟向前相容至 300 MB/s. 此硬碟可能在開機時無法被偵測到. 要安裝SATA-II硬碟, 必須透過硬碟的跳線帽設定, 將硬碟設定在150MB/s 傳輸速度(From ASUS)
不曉得你Hitachi的SATA是設定成I還是II的組態 且要先看"開機時有無被偵測到"到吧,再看安裝XP時給驅動後有沒有找到。 如有需要可能需用ftool調整之詳見Feture Tool |
多謝大大回我
拍謝問一個問題
跳線帽設定在硬碟的哪裡 要怎麼調呢... (說明書丟了.........) 以前的IDE硬碟在後面....SATA呢?? |
跳線帽是華碩寫的,應該是指別廠的吧,我沒有Hitachi HDD,我想應該是用ftool來修改的才是。
he Feature Tool allows you to: * Enable or disable the read-ahead or write cache. * Change the drive Automatic Acoustic Management settings to the: o Lowest acoustic emanation setting (Quiet Seek Mode), or o Maximum performance level (Normal Seek Mode). * Change the predefined capacity of the drive. This option can be used in situations where there is a BIOS limitation and the drive is not recognized. See the PDF Users Guide for specific details. * Switch the Ultra DMA mode * Change Advanced Power Mode - allows you to change between the lowest power consumption and the highest power consumption (maximum performance level). * Show Drive Temperature - shows the current drive temperature in Celsius and Fahrenheit. * Configure SATA interface - adjust maximum speed and enable/disable Spread Spectrum Clocking. Warning!: Switching your drive to support 3.0Gb/s, or enabling spread specturm clocking and then using it, may render your drive unusable in a system that can't support these functions. If in doubt, please contact your system manufacturer. |
感謝鼠大
如果連ftool 軟體也抓不不到呢........ 只抓到我的華X光碟機.. 這樣是什麼問題呢 |
上華碩的網站上看,有教sataII 的 jump接法
我前天才裝了兩顆160g sata II 的,所以應該不是主機板的問題唷 |
ftool如果也找不到的話,說不定是SATA排線接觸不良,我有遇過,把SATA線拔起重裝,先看SATA/BIOS有沒有偵測到吧。
|
我買的 H 牌 T7k250
是直接插上去, 就可以用啦... |
樓主應該可以不用試了
我前天幫人裝了一台偉格EQ3802準系統,用的是K8M800+8237R南橋 買的也是Hitachi 7K80,Hitachi原廠預設也是SATA I而已 裝上去也是不能動,偵測不到,裝在我的ICH6南橋上就可以動了 這是VIA的8237南橋Bug,只能換硬碟吧:) 不少人討論過了.......... |
謝謝大家
真的沒法支援A7V880.....
今天跑去給店員用叫我換別牌的 後來要換W牌的沒貨 換S牌....(之前壞軌過印象不好 又比較貴) 爬文說W牌讀取快...T牌的寫入快 S牌的呢???? 以後不想買VI晶片嚕... |
| 所有的時間均為GMT +8。 現在的時間是12:01 AM. |
vBulletin Version 3.0.1
powered_by_vbulletin 2026。