[HardOCP]Doom III Hardware Guide
 

http://www2.hardocp.com/article.html?art=NjQ0LDY=
中階顯卡搭配中階系統(Athlon2500+)篇

-

-

-

-

高階系統篇--AthlonXP3200+

-

-

-

-


圖片中設置為HardOCP建議的可遊玩graphic setting

http://www2.hardocp.com/article.html?art=NjQ0LDQ=

ATi VS Nvidia In Image Quality:

In our in-game evaluation, we did not notice any differences in image quality. However, when we started poring over the screenshots, we did notice some differences. If you look on the floor to the right side in the first comparison above, you will notice that the ATI Radeon X800XT-PE has slightly more aliased floor lines than the BFGTech GeForce 6800Ultra OC

Resolution:

What we noticed immediately is that DOOM 3 looks incredible even at 640x480! And as we increased the resolution, the game began to look more and more like a pre-rendered movie......That's correct. We found that increasing the resolution, up to 1280x1024 and 1600x1200, was simply a better alternative than using antialiasing

目前似乎只有GF6800U可以在可玩程度下嘗試Ultra High

-
DoomII重新定義那些舊世代顯示卡該有的效能表現
即使GF4MX440這類的顯示卡也表現出優秀的畫面於640X480

請問64MB的顯示卡是否只能在Low Quality下執行?
我的Ti4200只有64MB啊...

應該是可以啦
MX440都能玩了
若CPU和RAM不差的玩Low應該還過得去

看了一下畫面表現
覺得至少也要有High Quality
畫面才會比較細緻
Low和Medium真的是差很多
不過High和Ultra的差別我還看不太出來

不過玩Doom都玩得殺紅了眼
應該少有時間去管畫面精不精緻吧
玩得順暢才是重點 :cool:

Ti4200也能玩
希望這是真的.....:cry::cry::cry:

我是希望我的P-M 1.4G＋M9000可以跑得動
這樣就可以用筆記型隨時放鬆心情玩一下了

TI4200原本就能玩了....
好久好久以前....GF4 TI還是被列為建議配備.
記得是和R9700排同一等級(RUN DOOM3).

我不是問這個,而是說,是否需要128MB的RAM才可以跑Medium或以上的設定?
看這期的電腦玩家中說,64MB需要降低材質的解析度,怕雖是Ti4200但是只有64MB就只能跑Low.