PCDVD數位科技討論區 - 教我用Promise ATA100 driver

我用的mb是技嘉的7dxr 開機時都會顯示說沒driver
下載回來了~~但小弟我真的不會用可以教教我嗎!!謝謝
有說明文件內容是
Windows xp
Installing Driver During New Windows xp Installation
Note: Before the Windows xp installing, please copy the whole files in the folder as follows "other\promise\20265\ata100\winxp\Winxp\" of the TUCD (Support CD came with the M/B) to a floppy disk.
1. CD-ROM Install: Boot from the CD-ROM. Press <F6> after the message "Press F6 if you need to install third party SCSI or RAID driver" appears.
2. When the "Windows xp Setup" window is generated, press "S" to Specify an Additional Device(s)
3. Insert the Driver diskette into driver A: and press "Enter" key.
4. Choose "Winxp Promise Ultra DMA/ATA100 Controller" from the list that appears on screen, then press the "Enter" key.
5. The Windows xp Setup screen will appear again saying "Setup will load support for the following mass storage devices:" The list will include "Win2000 Promise Ultra DMA/ATA100 controller"..
NOTE: If you need to specify any additional devices to be installed, do so at this time. Once all devices are specified, continue to step 6.
6. From the Windows xp Setup screen, press the Enter key. Setup will now load all device files and then continue the Windows xp installation.

Confirming Windows xp Installation
1. From Windows xp, open the Control Panel from "My Computer" followed by the System icon.
2. Choose the "Hardware" tab, then click the "Device Manager" tab.
3. Click the "+" in front of "SCSI controllers." "Promise Technology, Inc. ULTRA DMA/ATA100 IDE controller" should appear.

麻煩了謝謝~~
如果可以的或可以替我講解一下這東東嗎?