![]() |
PCDVD數位科技討論區
(https://www.pcdvd.com.tw/index.php)
- 系統組件
(https://www.pcdvd.com.tw/forumdisplay.php?f=19)
- - K8...真是搞死H
(https://www.pcdvd.com.tw/showthread.php?t=408312)
|
|---|
引用:
要是先把Promise上的HD拔掉呢?? |
引用:
Thanks for the advise. I removed the Promise ATA controller and the situation is still the same. I called Gigabyte this morning, one technician suggested it was a RAM issue, the other said I need to load nVidia ATA drivers first. Both solutions failed. I will take my system back to the store tomorrow and see what they can do. At this point, I am starting to suspect a faulty ATA controller instead of drive failure because the chances of two harddrives crashing the same time is fairly remote. If that is indeed the case, I might come back with a 36G Raptor and another 200GB SATA tomorrow. (Maybe a FX-55 too... :hungry: If I can get one.) If it is a problem with the board, I hope the store can give me a replacement board. :D Thanks for any help. :agree: |
引用:
嗯 怪事發生 我這塊友通754 NF3 250GB搭配 GSKILL DDR還真是怪異 CPU跑200 DDR調 2/3除頻才能進XP CPU跑200以上 DDR居然可以同步跑 我CPU FSB調到 270*9,DDR 270可以同步,沒做進一步測試確認穩定性 但開機之後再重新開機要開2次才能進XP的毛病還存在 BIOS是914的 |
我的也出問題了,本來裝好後小超cpu 250x9 ram 200(除頻後)
結果prime95只跑8分鐘就error 再試不超頻,但ram設定在200,這樣1小時不到也error.... 確定不是cpu的問題就超了啊!直接來個cpu 265x9 ram 171(除頻後) 果然,這次完成1小時30分鐘還沒問題!繼續測試中.... 這要說甚麼呢?!DDR 400不能跑400,只能降頻跑個342什麼的怪頻率 我用的可是貨真價實的ADATA DDR400 ch-5啊! k8很好超,可是也很挑! 主機板k8ns ultra 939 cpu A64 3000+ ram adata ddr400 ch-5 512MBx2 |
引用:
沒辦法.....就只能這樣只跑100mhz 之前我更新的時候 只要開ie 3個以上就從新開機 也會出現藍天白雲 也就是說怎麼用怎麼死 之後我賣了又買同樣一塊就不敢再隨便更新bios 也就沒發生問題了 **************** 題外話有沒有人要跟我的創勝ddr433 512MB換創見ddr400 512MB 或是創見ddr400 512MB換創勝ddr433 512MB 有的麻煩密我一下吧!!~我已經搞到快沒錢換記憶體了說 :cry: |
引用:
你的KINGMAX 是什麼顆粒...我用kINGMAX ddr 500 Hynix 顆粒 現在BIOS用F4 都沒問題了,Frequency也是用200MHz...... 跑Prime95 Blend跟 Memtest都有過...你要不要去看看能不能去換這顆粒的... |
整個討論串看下來
加上之前K8N Neo2 Platinum 也是很挑ram 939的cpu加板子問題好像不少耶 不曉得是nforce的晶片不好還是amd 939的記憶體控制器不好 :confused: |
引用:
嗯,問題真的還頗多的~~~ 再觀望一陣子好了............ :fear: . |
引用:
其實沒有大問題啦! 只要有小朋友去換TCCD或hynix的記憶體,一切問題都解決了! 我不想再花大錢換記憶體了,只好將就用,雖然降頻,頻寬變小,有點不爽.但是使用上還是很順利的,而且少個幾百MB/s的頻寬不會有很明顯的效能下降. 我的例子是CPU超頻2400Mhz,記憶體降頻342,prime95 測試7小時半,沒問題! 溫度也只是待機43/全速55,涼快的很! |
我的939板子都是用K8T800 pro,用Winbond CH-5/TCCD都很正常,感覺上比nForce3 Ultra好裝多了 :)
|
| 所有的時間均為GMT +8。 現在的時間是04:15 PM. |
vBulletin Version 3.0.1
powered_by_vbulletin 2026。