另外編的RAID產品比較文件(部分產品比對), 有興趣隨便看看 :
http://j122251751.myweb.hinet.net/raid_products.7z

這是在下二號機更新完後轉成文字檔log
Adapter #0

==============================================================================
Versions
================
Product Name : PERC H700 Adapter
Serial No : 0AR02AF
FW Package Build: 12.10.1-0001

Mfg. Data
================
Mfg. Date : 11/09/10
Rework Date : 11/09/10
Revision No : A00
Battery FRU : N/A

Image Versions in Flash:
================
BIOS Version : 3.18.00_4.09.05.00_0x0416A000
FW Version : 2.100.03-1062
Preboot CLI Version: 04.04-010:#%00008
Ctrl-R Version : 2.02-0025
NVDATA Version : 2.07.03-0003
Boot Block Version : 2.02.00.00-0000
BOOT Version : 01.250.04.219

Pending Images in Flash
================
None

PCI Info
================
Vendor Id : 1000
Device Id : 0079
SubVendorId : 1028
SubDeviceId : 1f16

Host Interface : PCIE

Number of Frontend Port: 0
Device Interface : PCIE

Number of Backend Port: 8
Port : Address
0 4433221105000000
1 4433221106000000
2 4433221107000000
3 0000000000000000
4 0000000000000000
5 0000000000000000
6 0000000000000000
7 0000000000000000

HW Configuration
================
SAS Address : 5842b2b070ef1a00
BBU : Present
Alarm : Absent
NVRAM : Present
Serial Debugger : Present
Memory : Present
Flash : Present
Memory Size : 512MB
TPM : Absent
On board Expander: Absent
Upgrade Key : Absent
Temperature sensor for ROC : Absent
Temperature sensor for controller : Absent


Settings
================
Current Time : 1:11:32 3/25, 2011
Predictive Fail Poll Interval : 300sec
Interrupt Throttle Active Count : 16
Interrupt Throttle Completion : 50us
Rebuild Rate : 30%
PR Rate : 30%
BGI Rate : 30%
Check Consistency Rate : 30%
Reconstruction Rate : 30%
Cache Flush Interval : 4s
Max Drives to Spinup at One Time : 4
Delay Among Spinup Groups : 12s
Physical Drive Coercion Mode : 128MB
Cluster Mode : Disabled
Alarm : Disabled
Auto Rebuild : Enabled
Battery Warning : Enabled
Ecc Bucket Size : 15
Ecc Bucket Leak Rate : 1440 Minutes
Restore HotSpare on Insertion : Disabled
Expose Enclosure Devices : Disabled
Maintain PD Fail History : Disabled
Host Request Reordering : Enabled
Auto Detect BackPlane Enabled : SGPIO/i2c SEP
Load Balance Mode : Auto
Use FDE Only : Yes
Security Key Assigned : No
Security Key Failed : No
Security Key Not Backedup : No
Default LD PowerSave Policy : Controller Defined
Maximum number of direct attached drives to spin up in 1 min : 0
Any Offline VD Cache Preserved : No
Allow Boot with Preserved Cache : No
Disable Online Controller Reset : No
PFK in NVRAM : No
Use disk activity for locate : No

Capabilities
================
RAID Level Supported : RAID0, RAID1, RAID5, RAID6, RAID00, RAID10, RAID50, RAID60, PRL 11, PRL 11 with spanning, PRL11-RLQ0 DDF layout with no span, PRL11-RLQ0 DDF layout with span
Supported Drives : SAS, SATA

Allowed Mixing:

Mix in Enclosure Allowed

Status
================
ECC Bucket Count : 0

Limitations
================
Max Arms Per VD : 32
Max Spans Per VD : 8
Max Arrays : 128
Max Number of VDs : 64
Max Parallel Commands : 1008
Max SGE Count : 60
Max Data Transfer Size : 8192 sectors
Max Strips PerIO : 42
Min Strip Size : 8 KB
Max Strip Size : 1.0 MB
Max Configurable CacheCade Size: 0 GB
Current Size of CacheCade : 0 GB
Current Size of FW Cache : 394 MB

Device Present
================
Virtual Drives : 1
Degraded : 0
Offline : 0
Physical Devices : 3
Disks : 3
Critical Disks : 0
Failed Disks : 0

Supported Adapter Operations
================
Rebuild Rate : Yes
CC Rate : Yes
BGI Rate : Yes
Reconstruct Rate : Yes
Patrol Read Rate : Yes
Alarm Control : Yes
Cluster Support : No
BBU : Yes
Spanning : Yes
Dedicated Hot Spare : Yes
Revertible Hot Spares : Yes
Foreign Config Import : Yes
Self Diagnostic : Yes
Allow Mixed Redundancy on Array : No
Global Hot Spares : Yes
Deny SCSI Passthrough : No
Deny SMP Passthrough : No
Deny STP Passthrough : No
Support Security : Yes
Snapshot Enabled : No
Support the OCE without adding drives : Yes
Support PFK : No

Supported VD Operations
================
Read Policy : Yes
Write Policy : Yes
IO Policy : Yes
Access Policy : Yes
Disk Cache Policy : Yes
Reconstruction : Yes
Deny Locate : No
Deny CC : No
Allow Ctrl Encryption: No
Enable LDBBM : Yes
Support Breakmirror : No
Power Savings : No

Supported PD Operations
================
Force Online : Yes
Force Offline : Yes
Force Rebuild : Yes
Deny Force Failed : No
Deny Force Good/Bad : No
Deny Missing Replace : No
Deny Clear : No
Deny Locate : No
Support Temperature : No
Disable Copyback : No
Enable JBOD : No
Enable Copyback on SMART : No
Enable Copyback to SSD on SMART Error : No
Enable SSD Patrol Read : No
PR Correct Unconfigured Areas : Yes
Enable Spin Down of UnConfigured Drives : No
Disable Spin Down of hot spares : Yes
Spin Down time : 30
T10 Power State : No
Error Counters
================
Memory Correctable Errors : 0
Memory Uncorrectable Errors : 0

Cluster Information
================
Cluster Permitted : No
Cluster Active : No

Default Settings
================
Phy Polarity : 0
Phy PolaritySplit : 0
Background Rate : 30
Strip Size : 64kB
Flush Time : 4 seconds
Write Policy : WB
Read Policy : Adaptive
Cache When BBU Bad : Disabled
Cached IO : No
SMART Mode : Mode 6
Alarm Disable : Yes
Coercion Mode : 128MB
ZCR Config : Unknown
Dirty LED Shows Drive Activity : No
BIOS Continue on Error : No
Spin Down Mode : None
Allowed Device Type : SAS/SATA Mix
Allow Mix in Enclosure : Yes
Allow HDD SAS/SATA Mix in VD : No
Allow SSD SAS/SATA Mix in VD : No
Allow HDD/SSD Mix in VD : No
Allow SATA in Cluster : No
Max Chained Enclosures : 1
Disable Ctrl-R : No
Enable Web BIOS : No
Direct PD Mapping : Yes
BIOS Enumerate VDs : Yes
Restore Hot Spare on Insertion : No
Expose Enclosure Devices : No
Maintain PD Fail History : No
Disable Puncturing : No
Zero Based Enclosure Enumeration : Yes
PreBoot CLI Enabled : No
LED Show Drive Activity : Yes
Cluster Disable : Yes
SAS Disable : No
Auto Detect BackPlane Enable : SGPIO/i2c SEP
Use FDE Only : Yes
Enable Led Header : No
Delay during POST : 2
EnableCrashDump : No
Disable Online Controller Reset : No
EnableLDBBM : Yes
Un-Certified Hard Disk Drives : Allow
Treat Single span R1E as R10 : Yes
Max LD per array : 16
Power Saving option : All power saving options are disabled
Default spin down time in minutes: 30
Enable JBOD : No
TTY Log In Flash : No
Auto Enhanced Import : No
BreakMirror RAID Support : No
Disable Join Mirror : No
Time taken to detect CME : 60s


因為怕死所以更新完後目前只接上三顆沒啥重要資料的HD作測試XD

回報！
刷了A07，H700會卡在偵測完VD後，症狀跟A06一樣。
只好又刷回A02。
新的FW好像跟我主機板不太合...
(DFI LP UT X48-T2R)

感謝有網兄提供adpallinfo的資訊...
看來DELL不打算更新MegaRAID的版本了...

甚麼問題呢??

請問VXR大大
LSI9265這個新款的SAS卡
會有DELL 的板本嗎?


我十分好奇

就偵測完VD後就卡住，無法繼續完成開機動作。
A02沒有這個問題，A06 A07都會卡住...

翻之前版上其他討論串有一個類似的例子，但沒看到解決方案...

照以往的情況..
會有LSISAS2208版本...

依照以往DELL的做法..
LSISAS2208版本出來了..
應該就會把H700拋棄了...
連MegaRAID版本似乎都不做升級了....

恩....看來我不用試了
症狀一樣XD
我用的是LP-DK-X38-T2RS
順道一提 雖然更新到A06會卡住
但是把卡上的硬碟全拔掉又可以過
一整個詭異的情況